The Treatment of Water In The Wire and Cable

2023-05-23 257

Wires and cables should not be exposed to moisture, heat, corrosion or wear. Wire and cable should be checked for a period of time, found fault should be replaced in time. Wires and cables shall not be overloaded. Regularly check the use of electrical appliances and wiring in your home, and carry out timely maintenance and repair. For the lines of old buildings, it is found that they are flooded or wet, especially if the lines are aging with age, ask an electrician to repair them immediately. For lines that are easy to be soaked, please ask an electrician to move the lines and take overhead and moisture-proof measures. Rainy days such as power failure, should immediately cut off the power, electrician check the reason, and send someone to watch.


Power cable manufacturers tell you the maintenance of wire and cable.


The area around the machine should be kept clean and tidy at all times. No oil, water, materials or products shall fall to the ground. The waste generated in the process of production should be treated centrally and promptly. Wipe and clean the surface of the machine for good maintenance.


Ensure that the machine surface is clean at all times, tools are placed in accordance with the regulations, and items should not be placed on the machine surface. Add lubricating oil or cooling oil as required, and check regularly whether the oil supply system is clear.


There is no abnormal sound or vibration during machine operation, check and tighten fasteners regularly.


Transmission belt in the use of loose or metamorphic should be replaced.


All machine safety doors, safety grille, safety cover, safety switch, limit device is complete, normal, effective.


When wires and cables are laid through pipes, the external insulation is broken and water seeps into the cable.


After laying the wire and cable, the cable joints at both ends are not sealed and exposed to the air for a long time.


If the laying and storage work is not done properly, the terminal seal is not good, resulting in water vapor into the cable.


It also includes local failures caused by knocks on wires and cables during operation, as well as infiltration into cables.


Cable water treatment method.


After wiring and cable laying of electrical equipment is completed, please arrange cable ends and finish wiring in time to eliminate hidden dangers in communication seats.


If there is only water at both ends of the cable, simply cut the cable ends and reconnect the cable.


If the wire and cable of electrical equipment have obvious water inlet point, cut the cable near the water inlet point and connect it in the middle.


When there is water in the outdoor cable well or cable channel, the cable should be fixed with the height of the support as far as possible.


Conduct leakage test on wires and cables of electrical equipment regularly to understand the operation of cables.


To sum up: the treatment method of cable water is prevention! Because once the cable is in the water, it's basically abandoned. Therefore, power cable manufacturers remind you that the cable must be regularly checked and maintained in daily use.